Select Country
Login

Water Sensor for RMS Advanced

This product has been discontinued.

Water Sensor for RMS Advanced
This water sensor has been specially designed for use in monitoring and alarm systems. It was designed for use with the RMS Advanced, No. 32418. The unit must be powered using a 12V DC power supply. It is 100% waterproof. It reacts to any electrically conducting liquid such as water, alcohol, refreshments, acids and various chemicals. It gives an output when it comes into contact with a conducting liquid.
Part No.
32437
Manuals Date Size
Manual for Water Sensor for RMS Advanced 15.05.2007 293.69KB
Additional Information

  • Designed for use in monitoring and alarm systems on digital alarm inputs
  • For use with RMS Advanced (No. 32418, 32417 - not for use with RMS LITE 32419)
  • Ideal for detecting leakages from burst pipes etc. and condensation build-up in floor elevated rooms, water cooled server and network racks and other IT equipment.
  • Ideal for tunnel and channel leakage detection
  • Ideal for use in sumps and drain areas in case of overflows or pump failures

Function

The entire sensor is enclosed in a sealed water proof housing. The four V4A Steel sensors located on the bottom side of the unit detect any conducting liquid present. The unit uses an alternating current to detect the liquid. This prevents the sensors from corrosion due to electrolysis. The sensor is set to digital LOW in when active.

Technical Data

  • Operating voltage: 12 V DC, typical current: 1 mA at U=12 V DC
  • Sensor voltage max. 12 V / 6 kHz, sensor current: max. 0,2 mA
  • Operating temperature: -20°C ? + 60°C
  • Sensor activation: fix, min. 1mm of water
  • Over flooding 100% guaranteed, sensor is 100% water proof
  • Sensors: 4 pieces of V4A-steel
  • Cable: approx. 5m
  • Weight approx. 150g
  • Dimensions approx. 9 x 6 x 3cm
top

View Cart Your
Shopping
Cart

Your cart is empty

Newsletter
eNewsletter

Be the first to read about new products & offers!

First Name:

Email Address: